Siemens 6ES7153-1AA03-0XB0 - Page 244

Compatibilities between the IM 153-x
A.2 Compatibilities between the versions of IM 153-2 / -2 FO
ET 200M
244 Operating Instructions, 04/2022, EWA-4NEB7806006-09
Functions /
Interface module with order number 6ES7153-…
Update via SIMATIC Micro Memory Card
–
–
–
x
–
–
–
–
x
RC network with 10 MΩ for unearthed
configuration
-
(1 MΩ)
as of
E03
x
x
x
x
x
x
x
DPV1 mode
–
–
as of
E09
x
x
x
–
as of
E08
x
IQ-sense
–
–
–
x
(as of
FW
V3.0.1)
x
x
–
–
x
(as of
FW
V3.0.1)
E = module version
1
SYNC, FREEZE should not be used for these functions.
2
not when operating with the bus module BM IM/IM 6ES7195-7HD00-0XA0
3
supports expanded diagnostics with the 96-byte diagnostic frame in the spare part scenario
Retrofitting
You can retrofit the IM 153-2 with order number 6ES7153-2AA02-0XB0; module version 06
to the module version 07 - this is subject to a fee.
You can retrofit the IM 153-2 FO with order number 6ES7153-2AB01-0XB0, module version
05 to module version 06 - this is subject to a fee.
Contact your Siemens representative for this.
Behavior with inserting / removing interrupt
up to
153-2AA02, module version 06
153-2AB01, module version 05
as of
153-2AA02, module version 07
153-2AB01, module version 06
The ET 200M is set up on active bus modules. The
removal/insertion interrupt is disabled at parame-
ter assignment.
The removal or insertion of a module results in
station failure.
The ET 200M is set up on active bus modules. The
removal/insertion interrupt is disabled at parame-
ter assignment.
It is still, however, possible to remove and insert
modules. An interrupt is not reported, but the
events are displayed in the diagnosis.