Assignment planning
3.3 Configuration possibilities for PROFIBUS DP
ET 200M
38 Operating Instructions, 04/2022, EWA-4NEB7806006-09
Parameter assignment / operation of HART field devices
The following is required for the parameter assignment / operation of HART field devices:
• EDD (for ET 200M) Version V1.1.8 or higher
EDD (Electronic Device Description) is required to set up HART field devices. It is included
on the PDM Device Library CD (as of Edition 2, dated 2007) supplied with PDM.
• PDM V6.0 SP3
Note
If an older PDM version is used together with the EDD indicated above, an error message
However, then HART field devices on HART input/output modules that plug into slots
12
to 15 cannot be operated.
To Next Page
Loading...
