Commissioning
8.5 Commissioning with the STARTER commissioning tool
SINAMICS DCM DC Converter
292 Operating Instructions, 12/2018, A5E34763375A
Figure 8-9 Setting up the interface
Click
and set up the interface according to your device configuration.
Buttons
,
and
are now available.
Set S7ONLINE as access point.
Note
Connection via PROFINET IO with CBE20
To establish the connection via the additional module CBE20, see Chapter
"
Activating online
mode: STARTER via PROFINET IO
(Page 485)".
To Next Page
Loading...
