Commissioning
8.5 Commissioning with the STARTER commissioning tool
SINAMICS DCM DC Converter
294 Operating Instructions, 12/2018, A5E34763375A
Figure 8-11 Setting the interface – Properties
Note
PG/PC is the only master on bus
must be activated if no other masters (PC, S7, etc.) are
Note
Even if no PROFIBUS interface is installed in the PC, projects can be generated and
PROFIBUS addresses for the drive objects can be assigned.
Only the bus addresses available in the project will be offered. That prevents double bus
address assignments.
n required, a manual address entry can also be used to enter an already assigned
After completion, click
to confirm the setup and to return to the project wizard.
To Next Page
Loading...
