Siemens Connect X300 - Connect fire detection system to the portal

Commissioning
Connect fire detection system to the portal
7
34 | 52
A6V12153163_en--_e
7.5 Connect fire detection system to the portal
Copy Site-ID from the SintesoWorks
1. Open the SintesoWorks.
2. Select 'File' > 'Site properties'.
3. Copy 'Site ID'.
Register Connect X300 Gateway in the portal
 The Connect X300 Gateway is registered.
1. Select the App changer .
2. Select Sinteso Portal .
3. In the navigation bar, select 'Sites'.
4. In the status bar, select an alarm filter or enter the site name in the search field.
 The reduced site list displays.
 A warning displays on the unassigned site in the site list.