Fig. 1: Route in the Ethernet sub-net
Configuring permanent access for 'SintesoView'
1. Select the 'Hardware' task card.
2. Select the 'Station' for which you wish to configure permanent access for
SintesoView.
3. Select the 'SintesoView' tab in the detail editor.
4. Select the operation mode in the 'Permanent SintesoView access' field.
5. Load the configuration from the PC to the station.
Permanent access is configured.
You will find more information about 'SintesoView' in document Configuration
'009078', see 'Applicable documents [➙ 6]'.
You will find more information about the license key in document Planning
'008843'. See chapter 'Applicable documents'.
To Next Page
Loading...
