4. Select the 'Station' that you wish to display and/or operate and enter a valid
PIN.
5. Click on 'OK'.
The connection is established.
Connect from the Favorites list with 'Station'
Enabling for viewing and/or operating the 'Station' with SintesoView is granted.
The PC is connected to the 'Site'.
1. Select the 'SintesoView' task card.
2. Select 'SintesoView' > 'Connect to favorite' from the menu bar.
3. Select the desired 'Station' from the list.
The connection is established.
You will find a description of enabling for viewing and/or operating with
SintesoView in document 008838. See chapter 'Applicable documents'.
You can use the presettings to cause SintesoView to be connected automatically
with the most recently connected 'Station' when you open the task card
'SintesoView'.
See also
Applicable documents [➙ 6]
7.11 SintesoWorks Remote
The connection to the cloud enables remote access to the SintesoWorks.
Prerequisites
● Fire Tunnel Desktop Agent has been installed and is open in the background.
See ''.
● Sinteso Tunnel is connected in the Sinteso Portal. See ''.
Connection properties
To access the SintesoWorks, follow the steps from the 'Loading an existing 'Site''
section, setting the following values when you do this:
● Connection type: 'Connection to IP address'
● Value: '127.0.0.1'
To Next Page
Loading...
