EasyManuals Logo

Siemens Connect X300 User Manual

Siemens Connect X300
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
Commissioning
Connect tunnel
7
A6V12153163_en--_e
41 | 52
1. Select 'Commissioning' > 'Download site' in SintesoWorks.
The 'Download site' and 'Connect' windows open in SintesoWorks.
2. Select the connection in the 'Connect' window and click on 'OK'.
The 'Stations' are listed in the 'Download site' window.
3. Select the 'Stations' whose configuration you would like to load from
'SintesoWorks' to the 'Stations' and click on 'Start'.
The 'PathProvider configuration is missing.' window may open in
SintesoWorks with the 'Combination Resource type/Resource ID is not
registered!' prompt. Press <MENU> on the 'Station', enter the PIN and
press <ok>.
4. Click on 'OK' in the 'PathProvider configuration is missing.' window in
SintesoWorks.
The 'Action confirmation' window opens in SintesoWorks.
5. Click on 'Yes'.
The configuration is loaded to the 'Station'.
The progress is displayed in the 'Download site' window in SintesoWorks.
The 'Station' restarts.
After a few minutes, the 'Buzzer' sounds twice at the 'Station'.
6. Press <Acknowledge> on the Person Machine Interface at the 'Station' to
switch off the 'Buzzer'. Do not perform any more actions on the 'Station' until
the 'Buzzer' has sounded for the second time.
You will find more information about 'Loading configuration from the PC to the
station' in document '009078', see 'Applicable documents [ 6]'.
7.9 Connect tunnel
Sinteso Tunnel is remotely connected to the fire detection system via the Sinteso
Portal to use SintesoView and remotely access the SintesoWorks.
You must be properly trained on the particular tool to use the function.
7.9.1 Requirements
Check firmware in Asset Manager
Firmware ≥ FS20 Sinteso EN MP7 70.28 is required to use Sinteso Tunnel. Check
the firmware as follows:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens Connect X300 and is the answer not in the manual?

Siemens Connect X300 Specifications

General IconGeneral
BrandSiemens
ModelConnect X300
CategoryGateway
LanguageEnglish

Related product manuals