Proceed as follows to configure the 'Station' as 'GAP' or 'Secondary GAP':
'Station' is configured as a ↑ router station or ↑ Ethernet station.
1. Open the 'Global system configuration' > 'FS20 network configuration' >
'Ethernet sub-net' elements in the tree view of the 'Network' task card.
2. Highlight 'Functions' and open the 'Assign dialog' window.
3. Select 'GAP' or 'Secondary GAP' from the list and the reference for the 'Station'
you want from the tree.
4. Click on 'Assign'.
The 'Station' is defined as 'GAP' or 'Secondary GAP'.
Configuring GAP with DHCP server
The ↑ 'Station' is configured as GAP.
1. Open the 'Global system configuration' > 'FS20 network configuration' >
'Ethernet sub-net' > 'Functions' elements in the tree view of the 'Network' task
card.
2. Highlight the 'Station'.
3. Check the 'DHCP server enabled' checkbox on the 'Overview' tab of the detail
editor.
The 'Station' is configured with DHCP server.
Defining the 'Route' to the Gateway
Use the following network data:
● 'Destination address': IP address of the cloud gateway
● 'Netmask': '255.255.255.255'
● 'Gateway': In this context, GAP IP address of the 'Station'
'Gateway' refers to the Internet protocol parameters, not the physical gateway.
1. Select the 'Network' task card.
2. Open 'Global system configuration' > 'FS20 network configuration' > 'Ethernet
sub-net' in the structure tree.
3. Highlight 'Routes'.
4. Enter the network data.
To Next Page
Loading...
