7. Highlight the following element in the 'Operation' task card: 'Site' > 'Global
system configuration' > 'Global behaviour'
8. In the 'Overview' tab under 'Event 'Cloud gateway connection fault' enabled'
and 'Event 'Connection to cloud lost' enabled', set whether events relating to
the connection to the cloud gateway are to be displayed on the 'PMI' or not.
Information: The 'Cloud gateway connection fault' event is not a system error,
but is issued for information purposes only.
You will find information about these properties in chapter 'System behavior'.
You will find more information about 'System behavior' in document '009078', see
'Applicable documents [➙ 6]'.
Configuring a 'Station' as a router Station
'Assign dialog' window to define the router station
Proceed as follows to define the 'Router' or 'Standby router':
1. Open the 'Global system configuration' > 'FS20 network configuration'>
'Ethernet sub-net' > 'SAFEDLINK sub-net' elements in the tree view of the
'Network' task card.
2. Highlight 'Functions' and open the 'Assign dialog' window.
3. Select 'Router' or 'Standby router' from the list and the reference for the
'Station' you want from the tree.
4. Click on 'Assign'.
The 'Station' is configured as a router station or ↑ standby router station.
Configuring a 'Station' as GAP
To Next Page
Loading...
