Getting to Know Your OpenStage Phone
19
Programmable sensor keys
Your OpenStage 80 has nine (OpenStage 60: eight) illuminated sensor
keys to which you can assign frequently-used functions or numbers.
Depending on how they are programmed, you can use the sensor keys as:
• Function keys Æ page 83
• Repdial key Æ page 85
• Direct station selection keys Æ page 89
Touch the key to activate the programmed function or dial the stored num-
ber.
Press and hold a function key or repdial key to open a menu for program-
ming it. Direct station selection (DSS) keys can only be programmed via
the service menu.
A label for the function is displayed to the left of the key; it cannot be
changed. You can define the labeling for repdial or DSS keys according to
your requirements Æ page 91.
The status of a function is shown by the LED on the corresponding sensor
key.
Explanation of LED displays for programmed sensor keys
Increase the number of programmable sensor keys by connecting a
key module Æ page 15.
Only for repdial keys can you also program the second level for di-
rect destination selection.
LED Meaning of function key Repdial/Direct station se-
lection key
S
Off The function is deactivated. The line is free.
T
Flashing
[1]
[1] In this manual, flashing sensor keys are identified by this icon, regardless of the flashing
interval. The flashing interval represents different statuses, which are described in detail in
the corresponding sections of the manual.
The function is in use. The line is busy.
R
On The function is activated. There is a call on the line.
The programmable sensor keys on multi-line phones function as
trunk keys Æ page 114.
To Next Page
Loading...
