Siemens HydroRanger 200 - Page 266

Page 256 HydroRanger 200– INSTRUCTION MANUAL 7ML19985FC03
mmmmm
Parameter Charts
P110 Level Source [6 relay model]
P111 Relay Control Function
P112 Relay ON Setpoint
P113 Relay OFF Setpoint
P115
Relay Interval Setpoint [6 relay
model]
P116 Dead Band [6 relay model]
P118 Relay Output Logic
P119 Relay Logic Test
Pump Setpoint Modifiers
P121 Pump by Rate [6 relay model]
P122
Pump Service Ratio [6 relay
model]
Independent Relay Failsafe
P129 Relay Failsafe
Advanced Pump Control Modifiers
P130
Pump Run-On Interval [6 relay
model]
P131
Pump Run-On Duration [6 relay
model]
P132
Pump Start Delay [6 relay
model]
P133
Pump Power Resumption Delay
[6 relay model]
P136
Wall Cling Reduction [6 relay
model]
P137 Pump Group [6 relay model]
Flush Systems
P170 Flush Pump [6 relay model]
P171 Flush Cycles [6 relay model]
P172 Flush Interval [6 relay model]
P173 Flush Duration [6 relay model]
mA Output
P200 mA Output Range
P201 mA Output Function
P202 mA Output Allocation
P203 mA Output Value / Transducer
Independent mA Setpoints
P210 0/4 mA Output Setpoint
Parameter Altered Values for Indices/Point Numbers
# Name 1 2 3