Siemens LMV36.520 Series - 27 Service Level; Display of Service Level

175/248
Building Technologies Division Basic documentation LMV36... CC1P7544en
Infrastructure & Citiies Sector 27 Service level 25.09.2013
27 Service level
The service level is used to display information about errors including the error history and information about
the basic unit.

Note
When on the service level, you can press or to display the next or the previous
parameter.
Instead of pressing , you can also press
/
reset
for <1 s.

Note
Press
ESC
or
/
reset
for >3 s to return to the normal display.

Note
P
Vh
min s %
Bild 39e/0807
Parameter
Parameter value
Figure 97: Service level
No change of values on the service level.
If characters are displayed by the parameter, the value may consist of more than 5 digits.
Press
/
reset
for >1 s and <3 s to display the value.
Press
/
reset
for >3 s or
ESC
to return to the selection of the parameter (flashing).
27.1 Display of service level
/
reset
P
Vh
mi n
s%
Bild 21/0707
Press
/
reset
for >3 s until SEr appears.
When releasing
/
reset
, you are on the service level.
No. Parameter
Service level
954 Intensity of flame
960 Actual flow rate (fuel throughput in m³/h, l/h, ft³/h, gal/h)
945 Actual fuel
0 = fuel 0
1 = fuel 1
121 Manual output
Undefined = automatic operation
922 Incremental position of actuators
Index 0 = fuel
Index 1 = air
936 Standardized speed
161 Number of faults
701 Error history: 701-725.01.Code