114 | Part 3
(7) Expert Setting
➀ ▶Factor Min/Max. Tolerance: calculation factor for measured current value.
Factor min : 0~100, Factor max : 100~200
▶Color Load bar ok/Color Load bar alarm: color of axis load (for status display)
▶Calculate Tolerance : Automatically calculate measured current at tool setting screen.
Manual must be press soft key ‘Calculate Default’ at tool setting screen.
Automatic Automatically calculate measured current at tool setting screen.
▶Mode change/Calculate: Automatically mode change(Dimension Current Monitoring)
Manual must be change mode at program head section
Automatic Automatically mode change.(Dimension Current Monitoring)
▶Overwrite Database: Check for data storage before Dimension recording, Current
recoding
Automatic Automatically data storage(not check)
Acknowledge Check for data storage at special screen
Stop with Alarm not save data and cycle alarm occur
▶Axis selection: Automatically activate the channel according to the type and direction of
the tool at tool enable set screen.
Manual : Manually set channel at tool enable set screen
Automatic : Automatically activate the channel according to the type and direction of
To Next Page
Loading...
