Siemens RDF301.50 Series Basic Documentation

Siemens
RDF301, RDF301.50..., RDF600KN
Building Technologies
3.14.2
Control parameters can be adjusted via
commissioning or during normal operation with a tool like ACS
With
the
–
during commissioning via
–
during normal operation
Most parameters can be changed during nor
server or
ETS is an engineering tool and can be used for the full commissioning of the
KNX
thermostat
for the
∂
Setting RDF KNX parameters is only supported by ETS4 or higher / ACS version
5.11 or higher.
∂
The RDF KNX thermostats (without ETS parameter download) require version
ETS3f or higher
Connecting
section
ACS
OZW772 Web server,
RMZ792 bus operator
unit
ETS
Note:
Connecting a KNX tool
RDF301, RDF301.50..., RDF600KN
, RDF600KN/S Basic D
ocumentation
3.14.2
Parameter setting / download via tool
Control parameters can be adjusted via
bus either by
parameter download during
commissioning or during normal operation with a tool like ACS
the
ACS tool, the parameters can be changed…
during commissioning via
parameter
download (all parameters)
during normal operation
via Popcard (
most of the parameter
Most parameters can be changed during nor
mal operation using
server or
the RMZ792 bus operator unit.
ETS is an engineering tool and can be used for the full commissioning of the
thermostat
s
. Device address, application, control parameters and parameters
for the
switching groups can be defined and downloaded via ETS
Setting RDF KNX parameters is only supported by ETS4 or higher / ACS version
5.11 or higher.
The RDF KNX thermostats (without ETS parameter download) require version
ETS3f or higher
.
Connecting
a KNX commissioning / operating tool to the
section
4.2.
69 / 94
ocumentation
CE1P3171en
2017-12-07
Parameter setting / download via tool
parameter download during
commissioning or during normal operation with a tool like ACS
.
download (all parameters)
most of the parameter
s).
mal operation using
the OZW772 web
ETS is an engineering tool and can be used for the full commissioning of the
RDF
. Device address, application, control parameters and parameters
switching groups can be defined and downloaded via ETS
.
Setting RDF KNX parameters is only supported by ETS4 or higher / ACS version
The RDF KNX thermostats (without ETS parameter download) require version
a KNX commissioning / operating tool to the
RDF is described in

Siemens RDF301.50 Series Specifications

General

Brand	Siemens
Model	RDF301.50 Series
Category	Thermostat
Language	English