EasyManuals Logo

Siemens RDF301.50 Series Basic Documentation

Siemens RDF301.50 Series
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
79 / 94
Siemens RDF301, RDF301.50..., RDF600KN, RDF600KN/S Basic Documentation CE1P3171en
Building Technologies 2017-12-07
5. Supported KNX tools
5.1 ETS
ETS is an engineering tool. It can be used for the full commissioning of the RDF
KNX thermostats.
The following functions can be realized with ETS4:
Define and download the physical address
Define and download the application (plant type, control sequence)
Set up and download the thermostat's control parameters
Download the switching group parameters (RDF301.50, RDF600KN/S)
Set up and download group addresses.
This basic documentation does not describe how to operate ETS and commission
a device. Refer to the KNX Manual for more details.
Setting RDF KNX parameters is only supported by ETS4 or higher.
ETS4 can be updated online.
5.1.1 Parameter settings in ETS
For setting the parameters, open the project and select a device.
To start the parameter settings, select Edit, then Edit parameters.
The ETS version 3f or higher can be used to assign the communication objects
to group addresses (S-Mode).
The ETS4 or higher can be used to download the application and parameters.
ETS
STOP
Note!
Note:

Table of Contents

Other manuals for Siemens RDF301.50 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens RDF301.50 Series and is the answer not in the manual?

Siemens RDF301.50 Series Specifications

General IconGeneral
BrandSiemens
ModelRDF301.50 Series
CategoryThermostat
LanguageEnglish

Related product manuals