Description
Thermostat automatically changes between
heating and cooling
Thermostat is only allowed to heat
If "Morning warm-up" is received, the room
should be heated up as fast as possible (if
necessary). The thermostat will only allow
heating
Thermostat is only allowed to provide cooling
Not supported by fan coil applications
If "Pre-cool" is received, the room should be
cooled down as fast as possible (if
necessary). The thermostat will only allow
cooling
Thermostat is not controlling the outputs,
which means all outputs go to off or 0%
The thermostat should heat as much as
possible. The thermostat will only allow
heating
All control outputs are set to 0% and only the
fan is set to high speed.
Function will be terminated by any operation
on the thermostat
To Next Page
Loading...
Need help?
General
