Siemens RDF301.50 Series - Target Audience, Prerequisites; Glossary

8 / 92
Siemens………………………RDF301, RDF301.50..., RDF600KN, RDF600KN/VB, RDF600KN/S Basic Documentation CE1P3171en
Smart Infrastructure 2020-02-21
1.5 Target audience, prerequisites
This document assumes that users of the RDF KNX thermostats are familiar with
the ETS and/or Synco ACS tools and able to use them.
It also presupposes that these users are aware of the specific conditions associ-
ated with KNX.
In most countries, specific KNX know-how is conveyed through training centers
certified by the KNX Association (see www.knx.org/).
For reference documentation, see section 1.2.
1.6 Glossary
The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this document:
Parameters identified by this symbol are set using ETS.
Parameters identified by this symbol are set using the ACS tool.
Setting RDF KNX parameters is only supported by the following tool
versions:
– ETS3 or higher
– ACS version 5.11 or higher
Inputs and outputs identified by this symbol communicate with other KNX devices.
They are called communication objects (CO).
The communication objects of the RDF KNX thermostats work partly in S-Mode,
partly in LTE Mode, and partly in both. These objects are described accordingly.
A list of the parameters is shown in section 3.13.
ETS
ACS
STOP
Note!