Siemens SENTRON PAC2200 - Page 68

Commissioning
6.3 Parameterizing the device
PAC2200
66 Manual, 05/2018, L1V30415167B-02
"Digital output" parameter
The following functions can be assigned to the "Digital output" parameter:
● Energy pulse output; can be programmed for active or reactive energy pulses
● Indication of the direction of rotation
● Operating state display of the device
● Switching output for remote control via the interface
ACTION
Not used: Digital output is deactivated.
Device ready
: Digital output is activated.
Remote output
: The digital output is controlled by remote
access.
Direction of rotation
: Digital output is switched on by an
electric counter
-clockwise rotating field and remains active
for as long as the field is rotating in this direction.
Energy pulse
: Digital output signals the number of pulses
set for each energy unit (e.g. kWh). The energy counter
specified in the "COUNTER SOURCE" field is eva
luated
here.
Default setting: Not used
PULSES PER UNIT
The "PULSES PER UNIT" property is only visible if "Energy
pulse" is set for the "USAGE TYPE".
Range: 1 to 4000
Default setting: 1
PRO (output pulse divider)
The "Output pulse divider" property
is only visible if "Energy
pulse" is set for the "USAGE TYPE".
Range: 1; 10; 100; 1000
UNIT
Selects the type of cumulative power and the import value
that triggers the pulse when that value is reached.
Range: Counter import active energy (kWh), counte
r export
active energy (kWh), counter import reactive energy (kvarh),
counter export reactive energy (kvarh)
Default setting: Counter Import Active Energy (kWh)
The "COUNTER SOURCE" property is only visible if "Ene
r-
gy pulse" is set for the "USAGE TYPE".
PULSE DURATION
Duration of the energy pulses.
Range: 30 ms to 500 ms
Default setting: 100 ms
The "PULSE DURATION" property is only visible if "Energy
pulse" is set for the "USAGE TYPE".