Siemens SENTRON PAC2200 - Page 70

Commissioning
6.3 Parameterizing the device
PAC2200
68 Manual, 05/2018, L1V30415167B-02
"MODBUS RTU" parameter (optional)
The "MODBUS RTU" parameter is only available for devices with an RS 485 interface.
Address
1 - 247
Baud rate
4800/9600/19200/38400
Format
8N1/8N2/8E1/8O1/
Response time
0 - 255 ms
"M-BUS" parameter (optional)
The "M-BUS" parameter is only available for devices with an M-BUS interface.
Primary address
0 - 250
Secondary
ad-
dress
12345678
The secondary address is generated automatically from the serial number of the device.
Baud rate
1200/2400/4800/9600
Mapping
0-1.
"Display" parameter
Contrast
The display contrast can be adjusted in steps.
0 - 10 (default setting 5)
Brightness
The intensity of the backlighting can be adjusted in steps.
0 - 3 (default setting 3)
Dimming
The dimming setting of the display can be adjusted in steps.
0 - 3 (default setting 3)
Dim after
On expiry of the set period, the backlighting is dimmed to the set intensity.
0 - 99 (default setting 3)
Test indicator
Display test indicator