EasyManua.ls Logo

Siemens SICLOCK TC 400

Siemens SICLOCK TC 400
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation Planning
4-26
© Siemens AG 2007 All Rights Reserved
SICLOCK
®
TC 400
Use in residential areas and operation in the public network
If you operate the SICLOCK TC 400 in residential areas or in the public network,
you must ensure that it complies with the limit class B according to EN 55022 with
regard to the emission of radio interference.
The following measures are recommended to ensure the interference complies
with limit class B:
Installation of the SICLOCK TC 400 in grounded control cabinets / control
boxes
Use of filters in electrical supply lines
Use with additional measures
Applications where the use of the SICLOCK TC 400 or similar device requires
additional measures:
Locations with a high percentage of ionizing radiation
Locations with extreme operating conditions, such as
dust accumulation
corrosive vapors or gases
strong electric or magnetic fields
damp and wet rooms
strong oscillations, shocks, vibrations
strong radiant heat
In systems, which require special monitoring, such as
elevators
electrical plants in potentially hazardous areas
An additional measure, for example, would be to install the SICLOCK TC 400 in
a cabinet or housing.
Note
This is a a class A device. The device may cause RF interference in residential
areas or in the public network. In this case, the operator company may be held
liable for taking appropriate measures.

Table of Contents