Siemens SICLOCK TC 400

Configuration Tool
7-59
© Siemens AG 2007 All Rights Reserved
SICLOCK
®
TC 400
7.3.4 Reading parameters / writing parameters / resetting
parameters to factory settings
In online mode, you can individually read, write and reset parameters to their fac-
tory settings.
To initiate the "Read parameter", "Write parameter" or "Reset parameter to
factory setting" function:
1. Make sure that the configuration tool is connected to the device. See Estab-
lish/disconnect online connection (Section 7.2.1).
2. Select the desired parameter/entry in the parameter tree or parameter table.
3. Right-click the parameter or entry.
−> The context menu opens.
Left-click the desired function.
Figure 7-7 Context menu to read, write or reset parameter