Siemens SICLOCK TC 400

Parameterization and Operation on the Device
8-72
© Siemens AG 2007 All Rights Reserved
SICLOCK
®
TC 400
8.2.2 Parameter list
The parameter list is displayed after successful authorization, see Authorization
(enter password) (Section 8.2.1).
Optionally, the parameters can be set and checked via the configuration tool:
• Language
/Display/View/language (0.10.01)
• Ethernet settings
/Network Settings/Ethernet 1/IP Adapter 1 (0.05.01)
/Network Settings/Ethernet 2/IP Adapter 2 (0.05.02)
/Network Settings/Ethernet 3/IP Adapter 3 (0.05.03)
/Network Settings/Ethernet 4/IP Adapter 4 (0.05.04)
• Version
/Versions/Software Version (0.08.01)
/Versions/Hardware Version (0.08.03)
See also Parameterization (Section 9), Parameter Table (Section 10) and for
acknowledging messages General functions (Section 7.2).
Table 8-3 Parameter list
Language
ETH1 IP Address
ETH1 IP Subnet
ETH1 IP Gateway
ETH2 IP Address
ETH2 IP Subnet
ETH2 IP Gateway
ETH3 IP Address
ETH3 IP Subnet
ETH3 IP Gateway
ETH4 IP Address
ETH4 IP Subnet
ETH4 IP Gateway
Acknowledge events
Version