1-23
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03
1.3.11 Removing and Installing the Hard Disk
S If you are using the Box PC 820, remove the floppy disk/CD-ROM drive support
as described in Section 1.3.9.
S If you are using the PC FI45 V2, lower the floppy disk/CD-ROM drive support to
one side of the housing as described in Section 1.3.10.
S Remove the four screws with which the hard disk support is fastened to the
housing.
S Remove the disk drive connecting cables and lift the support carefully out of the
housing.
S Remove the four screws with which the hard disk is fastened to the
vibration-damped part of the support.
S Take the hard disk out out of the support.
To install the drive, proceed in reverse order.
Hard disk support
Fastening screws for
hard disk support
Fastening screws for
hard disk support
Figure 1-17 Removing the Hard Disk Support
System Unit
Siemens Distributor
To Next Page
Loading...
