Siemens SIMATIC Box PC 820 - Error Diagnostics

1-32
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03
1.6 Error Diagnostics
Error Cause Remedy
Power-ON LED does not light
up
S PC is switched off
S Power supply is not properly
connected
S Check power supply
connections, power cable and
power plug
The “Invalid configuration
information... Press the F1 key
for continue, F2 to run Setup
utility” appears on the screen
S Incorrect configuration data
S Buffer battery is low or
damaged
S Press “F2” key, check the
configuration data in SETUP,
enter any default values, and
check error messages in the
first SETUP menu
The “No boot device available”
appears on the screen
S There is no boot diskette in
the drive
S Wrong hard disk drive set in
SETUP
S Use the “Fixed disk function”
in SETUP
“Keyboard stuck key failure”
message appears
S A key has become blocked
during the system keyboard
selftest
S Check the keyboard
S Restart the system
Booting of the PC aborted after
several beeps
S An error has occured during
the system self-test
S Check the hardware
Every time a key is pressed, a
beep is heard and no charac-
ters appear
S Keyboard buffer overflow S <CTRL> <PAUSE>
Not-ready message when
trying to write to a diskette
S No diskette has been inserted
S Diskette has not been
formatted
S Insert diskette
S Format diskette
Write-protect error when trying
to write to a diskette
S Diskette write-protect
activated
S Write-protect hole open on
3.5” diskette
S Cancel write protection
“EPROM TSR Interface
disabled, check Power
Management” message
S “Programming Interface” has
been disabled in SETUP
S Enable “Programming
Interface” in SETUP under
submenu “FI Hardware
options”
COM1,COM2, LPT1 or MPI/DP
do not respond
S Ports have been disabled in
SETUP
S Enable COM1,COM2, LPT1
or MPI/DP in SETUP under
submenu “FI Hardware
Options.”
<\> key labeling missing S No original keyboard S German keyboard: <ALTGr >
< ß >, or <ALT> <9> <2>
S International keyboard:
<ALT> <9> <2>
<\> key is not displayed S Wrong keyboard driver is
being used
S Load correct keyboard driver
S <ALT> <9> <2>
PS/2 port keyboard trackball
does not function (FI45 V2)
S FI45 V2 PS/2 port does not
support trackballs.
System Unit
StockCheck.com