1-26
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03
1.3.13 Removing and Installing the Membrane Keyboard or Front
Components of the PC FI45 V2
After the device has been installed, the membrane keyboard or front components
can be exchanged from the front. Proceed as follows:
S Close the application you are using.
S Open the cover of the disk drive and remove the diskette or CD-ROM.
S Pull out the mains connector.
S Remove the 10 screws with which the membrane keyboard is fastened to the
front frame.
S Grip the cover of the disk drive carefully and pull the membrane keyboard
forwards and off.
!
Caution
There is nothing to prevent the keyboard from falling.
S Unplug the 40-pin connector from the front adapter module and disconnect the
interface cable carefully from the display.
S Remove the membrane keyboard and the front components mounted on it.
To install the membrane keyboard, proceed in reverse order.
System Unit
To Next Page
Loading...
