2-43
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03
Option “Primary / Secondary”
A branch is made to the following submenu when you select this type of menu
option:
PhoenixBIOS Setup Utility
Item Specific Help
F1
ESC
Help
Exit
Select Item
Select Menu
+ / –
Enter Select
Change Values F9
F10
Setup Defaults
Save and Exit
Sub-Menu
Type:
Cylinders:
[Auto]
Heads:
Sectors
Maximum Capacity
Main
Primary Master [8455MB]
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
[ 8940]
[ 15]
[ 63]
4326MB
[16 Sectors]
[Enabled]
[Enabled]
[FPIO 4 / DMA 2]
Ultra DMA Mode:
[Mode 2]
[AUTO] (recommended)
Autotypes installed
IDE-devices
[USER]
Enter parameters of
IDE-devices installed
at this connection
Figure 2-11 Example: “Primary Master”
The parameters which you can select here are usually saved on the respective IDE
drive, and are read from the drive and entered into the form when you select the
option “Autodetect Hard Disk.”
Option “Type”
If you select the option “Type” for a drive which does not exist, an abort is
executed after approximately one minute as a result of a timeout and the existing
entries remain unchanged. It is therefore only meaningful to carry out an
autodetect for interfaces to which drives are connected.
Under certain circumstances it may be necessary to deviate from the proposed
hard disk parameters. In this case, select the corresponding menu option and then
the desired value using the [+] and [-] keys. Enter “none” in the option “Type” if no
drive is connected, or a number from 1 to 39 if a predefined type of hard disk is to
be used.
Select “User” if you wish to define your own type of hard disk; you must then
additionally enter the hard disk-specific parameters in the options “Cylinders,”
“Heads,” “Sectors/Track,” “Write Precomp.”
Motherboard
Siemens Distributor
To Next Page
Loading...
