2-46
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03
Option “Boot Options”
The following submenu appears when you select the option “Boot Options” in the
main menu:
PhoenixBIOS Setup-Utility
Item Specific Help
F1
ESC
Help
Exit
Select Item
Select Menu
+ / –
Enter Select
Change Values F9
F10
Setup Defaults
Save and Exit
Sub-Menu
QuickBoot Mode:
SETUP prompt: [Enabled]
Main
Boot Options
[Enabled]
Allows the system to skip cer-
tain tests while booting. This
will decrease the time needed
to boot the system.
POST Errors: [Enabled]
Floppy check: [Disabled]
Summary screen: [Enabled]
Figure 2-13 ”Boot Options” Submenu
Quick Boot
Mode
Allows the system to skip certain tests while booting. This will decrease
the time needed to boot the system.
SETUP prompt During the system loading phase, the following SETUP prompt is output
at the bottom of the screen: PRESS <F2> to enter Setup.
POST Errors The loading procedure is aborted if an error is detected during the
system loading phase.
Floppy check During the system loading phase, the floppy head is moved by a number
of steppings to the inside, and then returned again. This test is useful
because the drive is initialized again in the process.
Summary
screen
The most important system parameters are output on the display at the
end of the system loading phase.
Motherboard
To Next Page
Loading...
