2-52
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03
Hard Disk Pre
Delay
[Disabled] No additional startup time for hard disk
3 to 30 Additional startup time for the hard disk
can be selected
Memory Gap at
15 MByte
[Disabled] The area from 15 to 16 Mbytes is not available
for ISA RAM
[Enabled] The area from 15 to 16 Mbytes is enabled for
the ISA memory.
Enable
memory ECC
[Disable] No “Error checking and correction”
[ECC Scrub] “Error checking and correction” are active
Only meaningful in connection with DIMM
cards with ECC
Default Primary
Video Adapter
[AGP] AGP-Slot on the motherboard is the main
VGA output interface
[PCI] Module in PCI-Slot is VGA output interface
Submenu COM/LPT Configuration
PhoenixBIOS Setup Utility
Item Specific Help
F1
ESC
Help
Exit
Select Item
Select Menu
+ / –
Enter Select
Change Values F9
F10
Setup Defaults
Save and Exit
Sub-Menu
Advanced
Base I/O address/IRQ:
[Enabled]Internal COM 1:
COM / LPT Configuration
Configure internal COM
port using options:
[Disabled]
No configuration
[Enabled]
User configuration
[Auto]
BIOS or OS chooses
configuration
[OS Controlled]
Displayed when
controlled by OS
Base I/O address:/IRQ
[Enabled]Internal COM2:
Mode:
[Enabled]
Base I/O address: [378]
Internal LPT1:
Interrupt: [IRQ 7]
[Bi-directional]
[2F8/IRQ3]
[3F8/IRQ4]
Figure 2-17 “COM / LPT Configuration” Submenu
If you set an interface to Disabled, the resources occupied by it are released.
Printer Port Internal LPT1
Mode: You can use this setting to select the operating mode of the printer inter-
face. You must adapt this setting to match the data terminal device which
you have connected. You can find the setting in the corresponding de-
vice documentation.
Motherboard
To Next Page
Loading...
