Siemens SIMATIC IPC377G User Manual

Maintaining and repairing the device
7.4 Installing and removing hardware
SIMATIC IPC377G
54 Operating Instructions, 07/2022, A5E51366314-AB
Procedure
Unscrew the marked five screws on the
bottom side of the box cover, and remove
the cover.
Slide the battery out 45 degrees from the
upper left, pull the battery out gently and
insert a new battery.
Note: The positive electrode (+) of the
battery should be positioned toward
the
outside of the device.
7.4.2 Replacing the memory module
Single channel memory
The motherboard provides one DDR4 memory sockets. The memory capacity of the device
can be upgraded to a maximum of 16 GB.
The table below shows the supported memory types of motherboard.
Module type
Module Size
Description
DDR4‐SDRAM
16GB
DDR4 up to 3200MT/S SODIMM 260pin
DDR4‐SDRAM
8GB
DDR4 up to 3200MT/S SODIMM 260pin
DDR4‐SDRAM
4GB
DDR4 up to 3200MT/S SODIMM 260pin
Requirements
• The device is disconnected from the power supply.
• All connecting cables on the device are unplugged.
• The device is opened.
• A T8 and a T10 screwdriver.
NOTICE
Electrostatic discharge
The electronic components on the PCBs are highly sensitive to electrostatic discharge.
Always take appropriate precautionary measures when handling these components. Refer
to the ESD directives on handling electrostatic sensitive components.

Siemens SIMATIC IPC377G Specifications

General

Brand	Siemens
Model	SIMATIC IPC377G
Category	Industrial PC
Language	English