KTP400 Basic, KTP600 Basic, KTP1000 Basic, TP1500 Basic
Operating Instructions, 08/2008, A5E01075587-01
21
Safety instructions and general notes
2
2.1 Safety instructions
Working on the control cabinet
WARNING
Open equipment
The HMI device is open equipment. That is, the HMI device may only be installed in
cubicles or cabinets which provide front panel access for operating the device.
The cubicle or cabinet in which the HMI device is installed may only be accessed with a key
or tool and only by trained, authorized personnel.
Dangerous voltage
Opening the cabinet will expose high voltage parts. Contact with these parts could be fatal.
Always disconnect the cabinet from the mains before opening it.
High frequency radiation
NOTICE
Unwanted operating states
High-frequency radiation, for example, from cellular phones, can trigger unwanted
operating states.
Installation as intended
WARNING
Installation only in machinery that conforms to the machinery directive
It is not allowed to commission the HMI device unless it has been verified that the machine
in which the HMI device is to be installed complies with Directive 98/37/EC. The following
applies as of December 29, 2009: The machine in which the HMI device is to be installed
must conform to Directive 2006/42/EC.
To Next Page
Loading...
Need help?
General
