Diagnostics and upkeep
7.8 Memory reset / reset to factory defaults
CP 443-1 Advanced (GX30)
104 Manual, 03/2019, C79000-G8976-C256-05
Follow the steps outlined below:
1. Connect the CP module to the PG/PC via a LAN cable.
2. Start the download on your PG/PC using one of the firmware download functions
described above.
You can find the corresponding LED displays in the section LEDs (Page 49).
Downloading new firmware via the update center does not affect the LED display.
The download involves two stages:
– Section 1: Downloading firmware
– Section 2: Activating firmware
3. After the firmware download, the CP goes through a warm restart.
If the download using the firmware loader is aborted, the RUN and STOP LEDs flash
alternately.
What to do if a download is interrupted
Disturbances or collisions on the network can lead to packets being lost. In such cases, this
can lead to an interruption of the firmware download. The firmware loader then signals a
timeout or negative response from the module being loaded. En entry is made in the
diagnostics buffer. The CP restarts with the firmware that existed before the aborted
download.
Repeat the download using the active MAC address after the CP has started up again.
If you cannot start the download again following an aborted attempt, you should turn off the
entire rack and turn it on again. You can then restart the firmware download.
Memory reset / reset to factory defaults
The CP has a two level function available for resetting:
● Memory reset
● Resetting to factory setting
The functions for resetting and resetting to factory defaults described here do not change the
configuration data on the CPU! Only the data kept on the CP (CPLUG and RAM) is deleted.
To Next Page
Loading...
Need help?
General
