Siemens SIMATIC NET CP 443-1 Advanced - 9 Approvals

CP 443-1 Advanced (GX30)
Manual, 03/2019, C79000-G8976-C256-05
111
Approvals
9
Approvals issued
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of the following approvals have been granted for your product by the
markings on the type plate.
Approvals fo
r shipbuilding are not printed on the device type plate.
Approval for CP and C-PLUG
The following approvals apply to the CP and the supplied C-PLUG.
EC declaration of conformity
The CP meets the requirements and safety objectives of the following EU directives and it
complies with the harmonized European standards (EN) for programmable logic controllers
which are published in the official documentation of the European Union.
●
94/9/EC (ATEX explosion protection directive, up to 19.04.2016)
Directive of the European Parliament and the Council of March 23, 1994 on the
approximation of the laws of the Member States concerning equipment and protective
systems intended for use in potentially explosive atmospheres
●
2014/34/EU (ATEX explosion protection directive, as of 20/04/2016)
Directive of the European Parliament and the Council of 26 Febrary 2014 on the
approximation of the laws of the Member States concerning equipment and protective
systems intended for use in potentially explosive atmospheres, official journal of the EU
L96, 29/03/2014, pages. 309-356
●
2004/108/EC (EMC up to 19.04.2016)
Directive of the European Parliament and of the Council of December 15, 2004 on the
approximation of the laws of the member states relating to electromagnetic compatibility.