Siemens SIMATIC NET CP 443-1 Advanced - Snmp

Configuration and operation
6.12 SNMP
CP 443-1 Advanced (GX30)
84 Manual, 03/2019, C79000-G8976-C256-05
6.12
SNMP
SNMP (Simple Network Management Protocol)
SNMP is a protocol for managing networks. To transmit data, SNMP uses the
connectionless UDP protocol.
The information on the properties of SNMPcompliant devices is entered in MIB files (MIB =
Management Information Base).
The CP supports data queries using SNMP in version 1. It delivers the content of certain MIB
objects according to the MIB II standard, LLDP MIB, Automation System MIB and
MRP Monitoring MIB.
The CP continues to support data queries via SNMPv3 (security enabled).
Supported MIBs
The CP supports the following groups of MIB objects of the standard MIB II according to
RFC1213:
● System
● Interfaces
● IP
● ICMP
● TCP
● UDP
● SNMP
● Address Translation (AT)
The other groups of the MIB II standard are not supported:
● EGP
● Transmission
The CP also supports the LLDPMIB according to IEEE 802.1AB, the PROFINET expansions
of the LLDPMIB (see also IEC 61158106), the Automation System MIB and the
MRP Monitoring MIB.