Siemens SIMATIC NET CP 443-1 Advanced - Page 112

Approvals
CP 443-1 Advanced (GX30)
112 Manual, 03/2019, C79000-G8976-C256-05
●
2014/30/EU (EMC, as of 20/04/2016)
EMC directive of the European Parliament and of the Council of February 26, 2014 on the
approximation of the laws of the member states relating to electromagnetic compatibility.;
official journal of the EU L96, 29/03/2014, pages. 79-106
●
2011/65/EU (RoHS)
Directive of the European Parliament and of the Council of 8 June 2011 on the restriction
of the use of certain hazardous substances in electrical and electronic equipment
The EC Declaration of Conformity is available for all responsible authorities at:
Siemens Aktiengesellschaft
Division Process Industries and Drives
Process Automation
DE-76181 Karlsruhe
Germany
You will find the EC Declaration of Conformity on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15353/cert)
> Entry type: "Certificates", certificate type: "EC Declaration of Conformity"
IECEx
The product meets the requirements of explosion protection according to IECEx.
IECEx classification:
● nA
IECEx classification: Ex nA IIC T4 Gc
Certificate no.: DEK 14.0034 X
The products meet the requirements of the following standards:
– IEC 60079-0 (Hazardous areas - Part 0: Equipment - General requirements)
– IEC 60079-15 (Hazardous areas - Part 15: Equipment protection by type of protection
"n")
● ec
IECEx classification: Ex ec IIC T4 Gc
Certificate no.: DEK 18.0019X
The products meet the requirements of the following standards:
– IEC 60079-0 (Hazardous areas - Part 0: Equipment - General requirements)
– IEC 60079-7 (Hazardous areas - Part 7: Equipment protection through increased
safety "e")
You can see the current versions of the standards in the IECEx certificate that you will find
on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15353/cert)
The conditions must be met for the safe deployment of the CP according to the section
Notices on use in hazardous areas according to ATEX / IECEx (Page 54).