Approvals
CP 443-1 Advanced (GX30)
Manual, 03/2019, C79000-G8976-C256-05
113
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
The product meets the requirements of EC Directive 94/9/EC "Equipment and Protective
Systems Intended for Use in Potentially Explosive Atmospheres" as of 19/04/2016 and the
requirements of EC Directive 2014/34/EU "Equipment and Protective Systems Intended for
Use in Potentially Explosive Atmospheres" as of 20/04/2016.
● nA
ATEX classification: II 3G Ex nA IIC T4 Gc
Certificate no.: KEMA 03ATEX1225 X
The products meet the requirements of the following standards:
– EN 60079-0 (Hazardous areas - Part 0: Equipment - General requirements)
– EN 60079-15 (Hazardous areas - Part 15: Equipment protection by type of protection
"n")
● ec
ATEX classification: II 3 G Ex ec nC IIC T4 Gc
Certificate no.: DEKRA 18ATEX0027 X
The products meet the requirements of the following standards:
– EN 60079-0 (Hazardous areas - Part 0: Equipment - General requirements)
– EN 60079-7 (Hazardous areas - Part 7: Equipment protection through increased
safety "e")
The current versions of the standards can be seen in the EU Declaration of Conformity, see
above.
The conditions must be met for the safe deployment of the product according to the section
Notices on use in hazardous areas according to ATEX / IECEx (Page 54).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
Until 19.04.2016 the CP meets the requirements of the EC Directive:2004/108/EC
"Electromagnetic Compatibility” (EMC directive) and as of 20.04.2016 the EC directive
2014/30/EC.
To Next Page
Loading...
Need help?
General
