Table of contents
CP 443-1 Advanced (GX30)
Manual, 03/2019, C79000-G8976-C256-05
11
6.11 Time-of-day synchronization ................................................................................................... 83
6.12 SNMP ...................................................................................................................................... 84
6.13 Ping: Permitted length of ICMP packets ................................................................................. 86
6.14 Use in the H system ................................................................................................................ 86
6.15 Using the CP for PROFINET CBA .......................................................................................... 87
6.15.1 CBA interface in the user program ......................................................................................... 87
6.15.2 Preparing for configuration with STEP 7................................................................................. 88
6.15.3 PROFINET CBA configuration with SIMATIC iMap ................................................................ 89
6.15.4 Using PROFINET CBA communication and standard communication at the same time ...... 92
7 Diagnostics and upkeep ........................................................................................................................ 95
7.1 Online security diagnostics via port 443 ................................................................................. 95
7.2 Diagnostics options ................................................................................................................. 95
7.3 The CP as Web server............................................................................................................ 96
7.4 Replacing older modules: Module replacement / upgrading .................................................. 97
7.5 Replacing older modules: CPs with configurable data management ................................... 100
7.6 Replacing a module without a programming device ............................................................. 101
7.7 Loading new firmware ........................................................................................................... 103
7.8 Memory reset / reset to factory defaults ............................................................................... 104
8 Technical specifications ...................................................................................................................... 109
9 Approvals ............................................................................................................................................ 111
A Documentation references .................................................................................................................. 117
A.1 On configuring, commissioning and using the CP ................................................................ 117
A.1.1 /1/ .......................................................................................................................................... 117
A.1.2 /2/ .......................................................................................................................................... 118
A.1.3 /3/ .......................................................................................................................................... 118
A.1.4 /4/ .......................................................................................................................................... 118
A.1.5 /5/ .......................................................................................................................................... 118
A.1.6 /6/ .......................................................................................................................................... 118
A.2 On installing and commissioning the CP .............................................................................. 119
A.2.1 /7/ .......................................................................................................................................... 119
A.3 For configuration with STEP 7 / NCM S7 ............................................................................. 119
A.3.1 /8/ .......................................................................................................................................... 119
A.3.2 /9/ .......................................................................................................................................... 119
A.3.3 /10/ ........................................................................................................................................ 119
A.3.4 /11/ ........................................................................................................................................ 120
A.4 On programming (blocks, OPC) ........................................................................................... 120
A.4.1 /12/ ........................................................................................................................................ 120
A.4.2 /13/ ........................................................................................................................................ 120
A.4.3 /14/ ........................................................................................................................................ 120
A.4.4 /15/ ........................................................................................................................................ 121
A.4.5 /16/ ........................................................................................................................................ 121
A.5 Industrial Ethernet security ................................................................................................... 121
To Next Page
Loading...
