Configuring with Web Based Management
5.9 "Security" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
227
Procedure
Entering a new server
To display a new server, follow the steps below:
1. In the relevant row, enter the following data in the input boxes:
– IP address or FQDN name of the RADIUS server.
– Port number of the input port
– Password
– Confirmation of the password
– Maximum number of transmission retries
– Primary server
2. Click the "Set Values" button.
1. In the relevant row, enter the following data in the input boxes:
– Server IP address
– Port number of the input port
– Password
– Confirmation of the password
– Maximum number of transmission retries
– Primary server
2. Click the "Set Values" button.
Repeat this procedure for every server whose entry you want to modify.
Client RADIUS Supplicant
Client Supplicant
On this page, you configure the settings for the RADIUS authorization of the client.
available in the client mode.
To Next Page
Loading...
Need help?
General
