Configuring with Web Based Management
5.3 "Wizard" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
53
●
Enter the MAC address of the client. The input box can only be edited if you have set
"Manual" for the "MAC Mode".
●
– Enabled
In client mode, the device attempts to connect to the network with the best
transmission quality and that has suitable security settings.
– Disabled
The client attempts to connect to the network from the SSID list that has the best
transmission quality.
Table 2 contains the following columns:
●
Shows the available WLAN interface.
●
Enter the SSID of the access point with which the client connects. In the Basic Wizard,
you can only specify one SSID. After completing the Basic Wizard, you can define further
SSIDs with "Interfaces > WLAN > Client".
Client Allowed Channel Settings
Introduction
For communication, a specific channel within a frequency band is used. On this page, you
can either set this channel specifically or configure so that the channel is selected
automatically.
Note
This page is only available in client mode.
To Next Page
Loading...
Need help?
General
