Configuring with Web Based Management
5.4 "Information" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
92 Configuration Manual, 11/2014, C79000-G8976-C350-03
●
Shows which authentication method is used.
If the authentication method "Open System + Encryption" or "Shared Key" is used,
"Encrypted (WEP/AES)" is displayed for both authentication methods.
●
Shows which iFeatures are used.
– -
iFeatures are not used.
– iPCF
iPCF is enabled.
●
Shows the maximum transmission rate of the interface.
●
Shows the status of the WLAN interface.
– enabled
The WLAN interface is enabled.
– disabled
The WLAN interface is disabled.
Available AP
Available access points
Note
This page is only available for clients or
access points in client mode.
This page shows all the access points visible to the client. The list also includes the access
points to which the client cannot connect due to its configuration.
Note
Display when iPCF mode is activated
If the iPCF mode is active with a SCALANCE W700, the display is different. Since the client
does not run a background scan in this case, only the access point with which the client is
currently connected is displayed.
To Next Page
Loading...
Need help?
General
