Configuring with Web Based Management
5.9 "Security" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
228 Configuration Manual, 11/2014, C79000-G8976-C350-03
The table has the following columns:
●
Shows the WLAN interface.
●
Enter the user name with which you want to log on to the RADIUS server.
●
Here, enter the password for the user name selected above. The client logs on with the
RADIUS server using this combination.
For password assignment, ASCII code 0x20 to 0x7e is used.
●
Dot1x User Password Confirmation
Confirm the password.
●
Dot1x Check Server Certificate
Specify whether or not the RADIUS server identifies itself to the client using a certificate.
●
Specify the authentication method. The following methods are available:
– Auto
EAP-TLS, EAP-TTLS or PEAP is used depending on the capability of the other
station.
– EAP-TLS
Client logs on using a certificate.
– EAP-TTLS
The client logs on with the RADIUS server using the user name and password
– PEAP
The client logs on with the RADIUS server using the user name and password.
1. Enter the necessary values in the input boxes.
2. Select the required entry in the "Dot1x EAP Types" drop-down list.
3. Click the "Set Values" button.
Keys
Specifying the WEP key
To allow you to enable the encryption for the "Open System" and "Shared Key"
authentication methods, you must first enter at least one key in the key table.
To Next Page
Loading...
Need help?
General
