Configuring with Web Based Management
5.3 "Wizard" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
42 Configuration Manual, 11/2014, C79000-G8976-C350-03
Buttons you require often
The WBM pages of the Basic Wizard contain the following buttons:
Goes to the next page
Goes back to the previous page
The Basic Wizard is closed without adopting the settings.
Saves the configuration and exits the Wizard.
Navigation within the pages of the Basic Wizard is possible only with the "Previous" and
"Next" buttons.
System Settings
Introduction
On this Basic Wizard page, you specify the mode of the device. After changing the mode, a
message is displayed.
If you confirm the message with "OK", the device restarts with the factory-set configuration
settings. Log on again and start the Basic Wizard to continue the configuration of the device
for the selected mode.
Note
Because only access points can work in client mode as well, the mode can only be selected
for these devices.
To Next Page
Loading...
Need help?
General
