Manual Contents
System manual
SIMATIC; PROFINET;
System description
● Overview
● Configuration/Configuration examples
● Data exchange and communication
● IO engineering
Documentation
PCS 7 - Released Modules
● Components released for redundancy in PCS 7
Guide
This manual is organized into the following topics:
● Basics of high availability in PCS 7
● Description of high availability solutions in PCS 7
● Description of configurations for various redundant components in PCS 7
● Failure scenarios and diagnostic options
● Options for quantitative analysis of high availability process control systems
● Glossary with important terms for understanding this documentation
● Index of important keywords
Conventions
In this documentation, the names of elements in the software interface are specified in the
language of this documentation. If you have installed a multi-language package for the
operating system, some of the designations will be displayed in the base language of the
operating system after a language switch and will, therefore, differ from the designations used
in the documentation.
If you use the operating system Windows 10, you will find the Siemens SIMATIC programs in
the Start menu under the menu command All apps > Siemens Automation.
Changes compared to the previous version
Below you will find an overview of the most important changes in the documentation compared
to the previous version:
As of PCS 7 V9.0
● Using the redundancy concept for PROFINET IO (Page 22)
● Using the redundant IO concept for ET 200SP HA (Page 38)
See also
High availability fieldbus based on PROFINET (Page 78)
High availability FOUNDATION Fieldbus (Page 90)
Preface
High Availability Process Control Systems (V9.0)
Function Manual, 05/2017, A5E39221836-AA 13
To Next Page
Loading...
