Siemens SIMATIC PCS 7 - How to Configure a Route Control Client

Result
The following figure shows an example configuration of a SIMATIC PC station with Route
Control application (stby):
Additional information
● Configuration manual Process Control System PCS 7; Engineering System ; section "How
to Expand a Project with Pre-Configured Stations Using the PCS 7 Wizards"
● Manual Process Control System PCS 7; SIMATIC Route Control
5.7.3 How to configure a Route Control client
Introduction
Below you find out how to configure a redundant Route Control client in HW Config.
Advantages of high availability components
5.7 SIMATIC Route Control stations
High Availability Process Control Systems (V9.0)
180 Function Manual, 05/2017, A5E39221836-AA