Installation of a CPU 41x-H
4-29
Automation System S7-400H Fault-tolerant Systems
A5E00068197-07
4.9 CPU 41x-H as Profibus DP Master
Introduction
This chapter details the properties and technical specifications you need when you
wish to use the CPU as a DP master and configure it for direct data
communication.
Note
This description applies to CPUs as of V 3.0.0.
Chapter Overview
In Section Description On Page
4.9.1 DP Address Areas of the CPUs 41x 4-30
4.9.2 CPU 41x as DP Master 4-30
4.9.3 Diagnostics of the CPU 41x as DP Master 4-35
Further References
You can find descriptions of and information on configuration as a whole, the
configuration of a PROFIBUS subnetwork and diagnostics in the PROFIBUS
subnetwork in the STEP 7 online help system.
Further information
You can find descriptions and information on changing from PROFIBUS DP to
PROFIBUS DPV1 on the Internet at the following address:
http://www.ad.siemens.de/simatic-cs
Under the item number 7027576
To Next Page
Loading...
