EasyManuals Logo

Siemens Simatic series Manual

Siemens Simatic series
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #109 background imageLoading...
Page #109 background image
Glossary
Glossary-17
SIMATIC Rack PC IL 40 SManual
A5E00200171-01
S
SCSI Interface
Small Computer System Interface. Interface for connecting SCSI devices (hard
disk drives, CD-ROM drives).
Serial Interface
Data is transmitted one bit at a time via a serial interface (port); serial interfaces
are therefore slower than parallel interfaces.
SETUP
A program in which information about the device configuration (that is, the
configuration of the hardware on the programming device) is defined. The device
configuration of the programming device is preset with defaults. Changes must
therefore be entered in the SETUP if a memory extension, new modules, or a new
drive are added to the hardware configuration.
SIMATIC S5 Memory Submodules
Memory submodules for SIMATIC S5 which are programmed with the PG and can
be plugged into an S5 programmable logic controller.
SIMATIC Memory Cards
Memory submodules in credit-card format for SIMATIC S5 and SIMATIC S7 which
are programmed with the PG and can be plugged into an S5 or S7 programmable
logic controller.
Software
The collective term for all programs which are used on a computer. The operating
system and the user programs are part of the concept “software”.
Standby
Power saving status: for example, hard disk drive or display turned off.
Startup Disk
The bootstrap instructions coded into a computers ROM (read-only memory) and
executed at startup. The startup ROM routines enable a computer to check itself
and its devices (such as the keyboard and disk drives), prepare itself for operation,
and run a short program to load an operating-system loader program.

Table of Contents

Other manuals for Siemens Simatic series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens Simatic series and is the answer not in the manual?

Siemens Simatic series Specifications

General IconGeneral
ProcessorIntel Core i3, Core i5, Core i7
Operating SystemWindows 10 IoT Enterprise, Linux
StorageSSD, HDD
InterfacesEthernet, USB, RS-232/485
PortsEthernet, USB, Serial
MountingDIN rail, wall
Protection ClassIP65
GraphicsIntegrated Intel HD Graphics
Expansion SlotsPCIe
Power Supply24V DC or 100-240V AC
Operating Temperature0°C to 50°C (depending on model)

Related product manuals