Preface
iv
SIMATIC Rack PC IL 40 SManual
A5E00200171-01
Structure of the Manual
In Chapters 1 to 4 the manual contains the most important instructions for starting
up and using the Rack PC. Chapters 5 to 9 are reference sections you will only
require in special cases.
Important Information
This chapter provides information about safety instructions, certificates, directives
and approvals.
Introduction
Before using your device for the first time you should read Chapter 2 to obtain
more information about the Rack PC components and their function.
Setting Up and Operation
The basic commissioning steps can be found in Chapter 3. Furthermore, you will
find instructions there on how to work with memory modules for automation
devices and further ports.
Expansion
Chapter 4 describes how to expand your Rack PC (for example, installation of
memory expansions). Please observe the safety instructions.
Configuration
Modifications to the system hardware may make it necessary for you to adapt the
original hardware configuration. You will find notes on how to proceed Chapter 5.
Error/Fault Dignostics
Chapter 6 will tell you how to deal with simple faults that you can diagnose and, in
some cases, eliminate yourself.
Hardware Information
Chapter 7 provides information on the system resources and connecting cables.
RAID Controller
You will find information on RAID Controller in chapter 8.
Reinstallation of the Software
Chapter 9 shows how to proceed in case you have to reinstall software.
ESD Guidelines
The guidelines for handling electrostatic sensitive devices in Chapter A are of
particular importance for service and maintenance engineers who install
expansions or carry out error analysis with the Rack PC.
Technical Specifications
Appendix B lists the valid technical specifications for your device. Detailed
information on how your Rack PC is equipped can also be found in the BIOS Setup
(key F2) under Info (key F1) > System Information.
To Next Page
Loading...
Need help?
General
