Siemens SIMATIC TDC - SB71 Pin assignment

Interface module
7.5 Interface module SB71
SIMATIC TDC hardware
System Manual, 08/2017, A5E01114865-AL
209
7.5.4
Pin assignment
Flat connector X1
Cable SC62 is used to connect the interface module to the SIMATIC TDC components (for
further information, refer to the documentation for the SIMATIC TDC components).
Digital outputs, terminal strip X2
Table 7- 6 Pin assignment of the digital outputs of interface module SB71
Terminal
Designation
1
Digital output 1
2 Digital output 2
3
Digital output 3
4 Digital output 4
5
Digital output 5
6
Digital output 6
7
Digital output 7
8
Digital output 8
51
0 V, digital output 1
52
0 V, digital output 2
53
0 V, digital output 3
54
0 V, digital output 4
55
0 V, digital output 5
56
0 V, digital output 6
57
0 V, digital output 7
58
0 V, digital output 8
Conductor cross-section
The minimum conductor cross-section for the terminal block X1 is 0.2mm² and the maximum
is 2.5 mm².
Aotewell Ltd
www.aotewell.com
Industry Automation
HongKong|UK|China
sales@aotewell.com
+86-755-8660-6182