Siemens SIMOTICS CONNECT 400 - Check Asset Data

3. Change the password in the "Password" 󹪝eld. The password must meet the following
requirements:
– Minimum of 6 characters
– Maximum 15 characters
– At least one uppercase letter (A-Z)
– At least one lowercase letter (a-z)
– At least one numeral (0-9)
– The following special characters are permitted: Hyphens (-) and underscores (_) are
allowed.
4. Enter the new password again in the "Repeat password" 󹪝eld.
5. Con󹪝rm your changes by pressing "Apply"
The user data are changed.
7.2.5 Check asset data
After onboarding, you can display the asset data stored in the connectivity module.
Operation
7.2Operation with iOS
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL 127