Siemens SIMOTICS CONNECT 400 - 8.3 Basic functions (Android)

8.3 Basic functions (Android)
You can 󹪝nd the most important basic functions for the connectivity module in the dashboard
view of the "SIDRIVE IQ Con󹪝g" application.
An overview of all of the basic functions is shown in the following table:
Function Description
Commissioning Starts the onboarding process for "SIDRIVEIQFleet".
Delete Asset (O󹪜board‐
ing)
The process to disconnect the connectivity module from the MindSphere application "SIDRIVE IQ
Fleet" - including deleting all data - is called o󹪜boarding.
O󹪜boarding is the precondition for a new commissioning process (onboarding) to "SIDRIVE IQ Fleet".
Send data to Mind‐
Sphere
Starts transfer of the measurement data from the memory of the connectivity module to "SI‐
DRIVEIQFleet".
Precondition: The onboarding process has already been performed.
Replace Motor
(only for "Motor Moni‐
toring")
Replacing the motor con󹪝guration without de-registering the asset from SIDRIVE IQ Fleet. You can
change the motor type, the serial number, the application, the operating point or the operating
mode. The new motor is continually monitored under the existing asset name. Data previously saved
in SIDRIVE IQ Fleet are not deleted.
Maintenance
8.3Basic functions (Android)
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL 135